9243单/多通道应变信号放大器

内置校准,电位分离,可通过DIP开关配置,易于安装在DIN安装导轨上,可选防护等级为IP65的版本

  • Features

    • 精度<0.05%
    • 模拟量电压输出0... ±5 V或0...±10V或电流输出0...20mA或4...20mA
    • 可接6线制和4线制传感器
    • 信号与电源之间的隔离
    • 截止频率1 kHz,可选配4kHz
    • 通过DIP开关进行配置
    • 易于安装在DIN安装导轨上(可选配IP67保护等级)
  • Description

    The amplifier module model 9243 is used wherever measurement signals from strain gauges, potentiometric sensors or DC/DC sensors have to be converted into standard signals. Simply by mounting on conventional DIN-mount rails, it is possible to position the amplifier module on location, in the proximity of the sensor. Especially for rough environments a IP65 version is available.

    The broad auxiliary power range and the choice between AC or DC permits operation on standard power supplies used in switch gear cabinets. A highly precise reference voltage source is built-in for calibration purposes. A calibrating shunt can also be connected via two separate terminals. This permits deliberate detuning of a strain gauge sensor for calibration or merely to check the measuring chain.

    A highly accurate precision amplifier performs the amplification of the sensor signal being applied. The necessary gain factor is adjusted coarsely with DIP switches while fine-tuning is carried out by using a potentiometer. Current and voltage outputs are available simultaneously. The sensor excitation is performed by the amplifier module itself so that no additional voltage source is required. It can also be set in steps of 2.5 V, 5 V, 10 V using DIP switches. The maximum feed current of 35 mA permits parallel connection of several strain gages, e.g. for the addition of measurement variables. Measurement errors brought about by varying line lengths or due to temperature fluctuations effecting the sensor cable are avoided by having probe lines measuring the actual feed voltage directly on site at the sensor itself (6 wire technology). Fluctuations are immediately corrected electronically. The cut-off frequency of the amplifier can be switched between 10 Hz and 1 kHz. The DIP switches for configuring the entire device are found easily accessible, under a cover.

  • Downloads

    Data sheet
    pdf 9243资料参数
    Operation manual
    pdf 9243使用手册

Related products

Product comparison

    © 2020 波司特精密仪器(上海)有限公司 沪ICP备12015704号沪公网安备31010602000957号