88600系列角度传感器

坚固,精确,高分辨率,免维护,免接触式传输,集成放大器,极低的惯性矩

  • Features

    • 测量范围高达160°
    • 非线性从±0.05%F.S.
    • 非接触式传输
    • 集成放大器
    • 坚固,免维护
    • 惯性矩很低
    • 根据要求提供特殊版本
  • Product data

    型号A 88600
    工作方式A 电容式,无接触环
    量程选择A ± 40 °
    0 … + 80 °
    0 … - 80 °
    ± 80°
    0 … + 160 °
    0 … - 160 °
    信号输出A 100 mV/° or 50 mV/°
    保护等级A IP40
    工作温度A 0 ... +75 °C
    供电电压A 15 V DC
    电气连接A Connector 5 pin
    可否连续旋转A Yes
    位移速度A 1440°/s
    具体特点A
    • 非线性从±0.05%F.S.
    • 非接触式传输
    • 集成放大器
    • 坚固,免维护
    • 惯性矩很低
    • 根据要求提供特殊版本
  • Description

    The 88600 series combines the precision of expensive optical angle encoders with high resolution and an analog output, without being subject to the restricted applications of potentiometric angle sensors.

    Typical applications:

    • Position feedback in servo-systems
    • Zero detectors
    • Pendulum weighing machines
    • Cam and butterfly flap positions
    • Twist angles
    • Angular actuators
    • Optical angle measurements
    • Jockey roller controllers

    This capacitive DC/DC angle displacement sensor with integrated amplifier only requires a DC voltage for a power supply and delivers an output voltage that is proportional to the angular position of the shaft. The shaft can be turned clockwise or counterclockwise with a permissible angular speed of up to 18,000 °/s (option).

    A highly accurate differential rotary capacitor is used to convert the angle into an electrical voltage. The integrated electronics consists of an oscillator, demodulator and amplifier. It can display the measurement signal directly or can, for instance, pass it to process monitoring equipment.

    Power supply and transmission of measured signals is without contact within the sensor. Operation is therefore maintenance-free. The precision roller bearings used give the sensor a long service life.

    Parts that are important for the function are made from material with no internal stresses and protected against corrosion.

    Mounting instructions

    The three threaded holes on the front plate (shaft side) allow the sensor to be mounted in any position. To determine the angular position of the measuring range, the shaft has a reference groove and the front face a reference hole (see rear).

     

  • Downloads

    Data sheet
    pdf 8860技术参数

Related products

Product comparison

    © 2020 波司特精密仪器(上海)有限公司 沪ICP备12015704号沪公网安备31010602000957号